Dynamic Engineering PMC2PCI Especificaciones descargar pdf (Pagina 19)

INTRODUCTION

PP 41x/03x 1-7

1.4 Additional Board Options

The PP 41x/03x board may be ordered with one of a few factory fitted configuration options, in

particular the Ethernet (on J3 connector):

• Configured for PICMG 2.16 backplane networking

• Configured for rear panel Ethernet via connectors (on RTM)

Two mezzanine mass storage options are available, namely:

• A 2.5 inch EIDE hard disk drive of at least 20 Gbyte capacity

• A dual CompactFlash carrier that also supports the Hitachi GST MicroDrive™

Refer to the PP 41x/03x datasheet for ordering information. The datasheet also details the

SDRAM capacity options.

NOTE: The mezzanine mass storage options use the PMC site 1 area. No PMC module

may be fitted in this site when a mezzanine mass storage option is fitted. PMC site 2 is

not affected by fitting a mezzanine mass storage option.

A bottom side cover is available. This protects the components on the bottom side of the board

from accidental damage or short circuits, particularly during hot-swap insertion and removal.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 127 128

Sin comentarios

Dynamic Engineering PMC2PCI Especificaciones Pagina 19